Operating Elements; Set Up - Omnitronic HM-115 Bedienungsanleitung

4.2 Operating elements

5 SET UP

1 Slide off the cover of the microphone. The battery compartment and the dip switches for channel
selection are now accessible.
2 Insert two 1.5 V mignon batteries (type AA) as indicated in the compartment.
3 Before switching on the microphone, set the corresponding receiver to an interference-free transmission
channel. Then set the microphone to the same channel with the dip switches (please refer to chapter 7.1
Channel configuration for a table listing which channel is assigned to which frequency):
1 2 3
CH CH CH
5 6 7
CH CH CH
9 10 11
CH CH CH
13 14 15
CH CH CH
4 Replace the cover.
5 Set the sliding switch to the upper position ON to turn on the microphone. The red battery indicator
shortly lights up and indicates that there is sufficient power. If the indicator does not light up there are
either no batteries inserted or the poles are wrong.
6 With new batteries, the microphone can be operated for approx. 12 hours. If the red battery indicator
lights up steadily the batteries are exhausted and must be replaced.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take discharged batteries to a collection center near you.
After operation, set the sliding switch to the lower position OFF to switch off the microphone. If the HM-
7
115 is not used for a longer period (approx. 1-2 weeks), please remove the batteries to prevent
damage in case of battery leakage.
4
CH
8
CH
12
CH
16
CH
Danger of explosion when battery is replaced improperly.
BATTERY DISPOSAL NOTICE
Please dispose of discharged batteries properly.
CAUTION!
9/10 00046291.DOC, Version 1.3