Access Control Function - Hama N300 Bedienungsanleitung

7.2.1 Access control function:

The Access control option contains the settings required for setting up a MAC address filter.
This filter allows you to explicitly define which WLAN devices may and may not use the repeater.
If, for security reasons, you wish to define which WLAN devices may log onto the repeater and
thus onto your network, you must have detailed knowledge of MAC addresses. This manual does
not tell you how and where to find MAC addresses; it only explains how to set up this option on
the repeater.
• Activate access control by adding a check in the Enable access control checkbox.
• Enter all previously noted MAC addresses in the MAC address box, one after another.
• After each entry, click Add before continuing with the next MAC address. You can add notes in
the comment box to keep better track of the different MAC addresses. For instance, you might
enter "Tablet" if the MAC address belongs to a tablet or "Living room" if the device with this MAC
address is installed in the living room.
Note – MAC address
► Information on entering the MAC address: You must enter the address without "-"
or ":".
► Please note that no more than 20 entries (20 devices) are possible.
Once you have entered the MAC addresses, you will find them displayed in the MAC address
filter table. If you wish to remove individual entries or all entries, highlight the particular entries
and click Remove selected or Remove all. Clicking Reset also removes all the entries you have
selected.
To save the settings, click Apply. The next window confirms that the settings have been saved.
WLAN 300 Mbps Repeater
15