Hama N300 Bedienungsanleitung Seite 6

► Max. data transfer rate: The connection to your WLAN router is stable and the
► Good data transfer rate: The connection to your WLAN router is not optimal but
► Adequate data transfer rate: The connection to your WLAN router is active but
WLAN LED (2):
Steady blue light
Flashing blue
Off
Power LED (3):
Steady blue light
Flashing blue
Blue light is off
WPS LED (4):
Steady blue light
Flashing blue
Blue light is off
LAN LED (5):
Steady blue light
Blue light is off
WPS button (6)
This button can be used to connect/link the repeater to your WLAN router using WPS; it can also
be used to reset the repeater to the factory settings in case of a malfunction. To make a connec-
tion/link using WPS, please read the section Start-Up Using WPS.
6
Note - Data rate
max. data transfer rate available via WLAN/WiFi can be achieved.
is still sufficient; the max. data transfer rate available cannot always be achieved.
only barely. You cannot be sure that the connection will not be interrupted. The
data transfer rate drops to the minimum. We recommend moving the WLAN repea-
ter nearer to your WLAN router until the LED indicates a "good" data transfer rate.
(Note that the repeater may require approximately 2 minutes until the new location
is indicated by the signal LED.)
The WLAN repeater is ready for operation.
The WLAN repeater is starting or linking via WPS is currently taking
place.
The WLAN repeater is unplugged.
The WLAN repeater is ready for operation.
Data transfer
The WLAN repeater is unplugged.
WPS is activated.
Linking via WPS is currently taking place.
WPS is deactivated.
A cable connection to the WLAN repeater has been established.
A network cable has not been connected to the WLAN repeater, or the
device that is connected via a cable to the WLAN repeater is switched
off.
WLAN 300 Mbps Repeater