Scheppach SC36 Originalbetriebsanleitung Seite 15

Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
we hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
WE RECOMMEND:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
Read the instruction manual each time before op-
erating the machine and carefully follow its informa-
tion. The machine can only be operated by persons
who were instructed concerning the operation of the
machine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to
the operation of identical devices must also be ob-
served.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
Device Description (Fig 1-2)
1. Shift lever
2. Safety switch
3. Upper push bar
4. Mains connection/mains cable
5. Tensioning lever
6. Middle push bar
7. Catch basket
8. Lower push bar
9. Handle height adjustment
10. Working height adjustment
11. Rear wheel
12. Front wheel
A. Allen key size 5
B. Cable strain relief
C. Cable clamp
D. Aerator roller
Unpacking
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
Intended use
The equipment can be used both as a scarifier and
an aerator depending on the intended use. Only a
few movements are required to change the roller.
The scarifying roller is designed for ripping moss
and weeds - complete with their roots - out of the soil
and for loosening the soil. As a result your lawn can
absorb nutrients better and is cleaned. We recom-
mend you to scarify your lawn in the spring (April)
and autumn (October).
The aerating roller scratches the surface of the lawn,
helping water to drain off more easily as well as pro-
moting oxygen intake. Aerate your lawn throughout
the growing period.
GB 15