Use; Cleaning The Floor - Cleanmaxx JJ-SC-005B Gebrauchsanleitung

EN
1. Take the water tank out of the appliance to fi ll it. To do so, depress both side release
buttons (6).
2. Open the water tank: Turn the water tank lid (5) a bit in a counterclockwise direction
and remove it.

Use

Read the safety instructions prior to use!

Cleaning the Floor

NOTE!
■ To use the device on laminate fl ooring, the following must be ensured:
– The laminate must be properly laid and have no gaps or cracks into which moisture
could penetrate.
– Test the device fi rst on an inconspicuous spot. Then check it for any waves or
ingress of moisture. If the test spot is unblemished, the device can be used to
clean the entire laminate fl oor.
■ Before using the device, always check the fl oor cloth for signs of wear. A fl oor cloth
that is worn or has holes in it must not be used. The fl ooring could be damaged.
■ If the device is parked after use, a wet spot may form beneath the cleaning foot.
With sensitive fl oors, a cloth should therefore be placed beneath the cleaning foot or
parking for a prolonged period of time should be avoided.
1. Give the fl oor a general sweep or vacuum before using the device.
2. Mount the handle bar (B) with the handle (C) and the cleaning head (N) on the main
unit (A). Attach the fl oor pad (L) to the cleaning head and, if you would like to clean a
carpet, the carpet glider (O) (see chapter "Assembling the appliance").
3. Fill the water tank (7) (see chapter "Filling the water tank").
4. In order to unwind the power cord, turn the top hook (2) of the cord spool down. Hang
the power cord in the cord holder (3) for better handling of the steam cleaner when
cleaning fl oors and so that you do not trip over the cord.
7. Insert the mains plug in a properly installed socket that is easily accessible. The
power LEDs (12) behind the water tank will illuminate in red as soon as operating
08337_DE-EN-FR-NL_A5_V4.indb 24 08337_DE-EN-FR-NL_A5_V4.indb 24
24
3. Fill the tank with cold, clean water. You can use the
enclosed measuring cup (K) to do so. The tank holds up
to 350 ml.
4. Screw the water tank lid back onto the water tank by
turning it in a clockwise direction and then insert the tank
back into the main unit. It must audibly lock into place.
5. Turn the knob for the steam quantity control (8) to the
minimum setting by turning it counterclockwise until it
comes to a stop.
6. Park the appliance in an upright position. The hinge of the
cleaning head locks in when in an upright position.
14.02.2018 14:06:23 14.02.2018 14:06:23