REVELL MICRO HELICOPTER PYTHON Bedienungsanleitung Seite 7

1. gettiNg StArteD:
The actuating regulator (the left-hand regulator on the
remote control unit) must point downwards before
switching on. Then set the ON/OFF switch of the
remote control unit to ON (Fig. 1). The LED will start to
flash. Move the actuating regulator once all the way
up and all the way down again. The LED now lights
up permanently and remote control is ready. Use the
channel selector (Fig. 2) to select the desired channel
for the helicopter.
2. triMMiNg tHe CoNtroLLer:
Correct trimming is crucial for ensuring that the helicopter flies smoothly. It is easy to do, but does require a little patience and a light touch. Please observe the following guidelines precisely:
Move the actuating regulator carefully upwards to make the helicopter move approximately 0.5 to 1 metre upwards.
If the helicopter keeps
turning quickly or
slowly to the right...
If the helicopter turns quickly or slowly to the right by itself, turn the wheel for left/right
trimming counterclockwise until the helicopter no longer turns by itself.
3. FLigHt CoNtroL:
In order to start or to fly the helicopter higher, push the actuating regulator carefully forward.
To move forward, carefully push the direction stick forward.
To make left turns, carefully push the direction stick to the left, provided that the tail of
the helicopter is pointing towards the pilot.
Flying the Helicopter
pic. 1 pic. 2
Now switch the
ON/OFF switch on
the underside of
the helicopter "ON".
If the helicopter keeps
turning quickly or
slowly to the left...
If the helicopter turns quickly or slowly to the left, turn the wheel for left/right trimming
clockwise until the helicopter no longer turns by itself.
In order to land or to fly lower, move the actuating regulator backwards.
Minimal corrections to the regulator are required to allow the helicopter to fly smoothly.
To move backwards, carefully pull the direction stick back.
To make right turns, slowly push the direction stick to the right, provided that the tail
of the helicopter is pointing towards the pilot.
Place the helicopter on the
ground so that the
fuselage is pointing
towards you.
As soon as the search light
stops flashing, the
helicopter is ready to fly.
7