Maintenance Notes - Rehau RAUTOOL M1 Bedienungsanleitung

RAUTOOL M1

MAinTenAnce nOTes

Regular inspection:
- Always keep jaw sets, expander heads and cylinder clean .
If they become dirty, clean them with a brush and then oil
them . The tool should then be stored dry .
- Before each use, check the jaw sets, the expander and the
tool for damage or visible wear . Damaged tools must no lon-
ger be used and should immediately be sent for repair to an
authorized service center .
Grease the inside of the cylinder regularly (tube of lubricant enclosed),
keeping the outside surface of the cylinder dry. Do not grease the
compression jaws.
Regularly grease the taper of the expander (tube of lubricant is sup-
plied). Do not grease the taper excessively to prevent excess grease
from entering the pipe.
Caution:
Do not apply grease to expanding segments that come in contact with
the pipe. Keep outer surfaces
free of grease.
Repairs:
Risk of accident!
Do not perform any repairs on the tool yourself .
Repairs should only be carried out by an authorized service
center .
Storage:
Never store a wet tool! Dry the tool and grease it . Then store
the tool dry .
28
- During compression, the sets must close fully and the
compression sleeves must be pushed up to the fitting collar .
- Regularly remove the grease from the taper of the expander .
There should be no grease on the surface of the expanding
segments! Should excess grease reach the expanding
segments, clean the segments carefully (for example with
cleaner's naphtha) and then dry them .