Tool Preparation - Rehau RAUTOOL M1 Bedienungsanleitung

RAUTOOL M1

TOOL pRepARATiOn

Caution! Risk of injury!
Improper handling of the REHAU tool can cause harm to people
and/or damage the tool .
Expanding tool
Expander:
When changing expander heads
open expander completely
(> 90° position). Always screw
expander heads fully on. Use
expander heads of a size confor-
ming to the pipe dimensions (for
example 16 x 2,2)
Attention!
Always insert the expanding tool
into the pipe up to the stop!
22
- During every change of the jaw sets, make sure that the pins are
inserted completely and safely.
- Before each use of the jaw sets check the expander and the tool
for damage or visible wear. Damaged tools may no longer be used
and should immediately be sent to an authorized service center.
- When introducing the expander, always insert it completely into
the clamping jaw and fix it with the set screw.
Expander set
Pipes of dimension 40 are
expanded using the expander bit
M1. For that purpose, insert the
expander bit into the clamping
jaws M1 40 and fix it with the
retaining screw.
Before operating the tool, the
correct fit and the compression
effect of the expander bit in the
clamping jaws must be checked
(the expander bit must sit tightly
in the clamping jaws and may not
fall out!)