Rehau RAUTOOL M1 Bedienungsanleitung Seite 25

6. Bring selector button into sliding position (upper position of button).
7. Actuate lever to push compression sleeve up to fitting collar.
Caution:
End the compression process immediately when the compression
sleeve is flush with the fitting collar. Avoid „over-pressing" the fitting
components (damage to the fitting components / jamming of the
tool).
8. Move selector button to reset position (button down to the side).
9. Press lever again until safety catch is released. Then move lever
up 90° to return tool to starting position.
10. Completely compressed compression sleeve connection.
Processing at temperatures of under -10°C and over 45°C may
result in damage to the connection components, the tool and/or
people .
- Do not work below the minimum processing temperature
of 10°C .
- At low temperatures (below 0°C), it is recommended that the
connecting components be pre-positioned in a warm
environment before processing .
25