Inhaltsverzeichnis
Werbung
VENTILATIoN of THE SAuNA RooM
In order to maintain fresh and easy to breathe air inside the Sauna Room sufficient ven-
tilation is extremely important. During one hour the Sauna Room air shall be exchanged
6 times at least. If possible, fresh air should flow directly from outside above the heater.
Stale Sauna Room air shall escape through a ventilation louver located as far as possible
from the Sauna Heater near floor level.
NoTE: Heat protection material such as mineral board which is directly attached to the
wall or ceiling of the sauna room, may raise the temperature of the wall and ceiling mate-
rials dangerously high. Consult local building safety authorities to determine which part of
the fireproof wall may be insulated. In order to avoid damage to flooring underneath the
heater caused by hot stone crumbs, only dark joint grouts and stone based floor material
should be used. Any light joint grout often used for tile flooring which absorbs impurities
easily as well as plastic floor coverings are not recommended.
Due to wall surface processing with protective panel agents wall blackening can occur.
It is expedited by sunlight and heat from the Sauna Heater. The maximum allowable
temperature for wall and ceiling surfaces in the sauna is +140° C. Our Sauna Heaters
meet applicable safety standards and directives and the production is being monitored by
reputable Third Parties annually.
CoMbI HEATER ouTpuT
The Combi Heater power output is determined by the volume and elements of the Sauna
Room, such as glass windows, concrete or tile surfaces. Each square meter of said wall el-
ements increase the volume of the heated sauna room by 1.2 cubic meter. It is important
to have sufficient insulation behind wall and ceiling panels to prevent wastage of heater
power. Log sauna room's volume shall be multiplied by 1.5 since walls made of logs are
heated up slowly.
Abb 11
Belüftung der Saunakabine
Fig. 11
Sauna room ventilation
A
B
C
25
ENGLISH
Werbung
Inhaltsverzeichnis
