Safety Instructions - Knurr CoolServe Betriebsanleitung

CoolServe
Manual / Bedienungsanleitung
1.2

Safety instructions

Our engineers will provide comprehensive support on how to install
the CoolServe.
Extensive material, function and quality checks ensure that you
fully benefit from product functions and a long service
life. Nevertheless, this product can produce hazards if it is used
incorrectly by untrained personnel or is not used for the correct purpose.
Prior to commissioning the CoolServe, read these
operating instructions carefully.
The electrical equipment complies with the applicable VDE and accident prevention regulations.
Hazardous voltages (higher than 50 V AC or higher than 100 V DC) are present:
 inside the enclosure
 at the feed to mains units
Use only original fuses with the stipulated rating.
Immediately shut down the unit if there are problems with the supply of electrical power or supply
of cold water.
Risk of electric shock
Repair and cleaning work should only
be performed by qualified personnel.
The personnel must ensure that the unit is electrically
isolated whilst it is serviced and cleaned. For this reason
shut down the unit before starting work.
Risk due to incorrect work on the unit.
Cleaning and servicing is only allowed to be performed by
qualified personnel. To ensure that the unit remains
safe to use and has a long service life, it is imperative
that you observe the maintenance and cleaning intervals.
CoolServe
Important note, information
01_998_345_0_a page / Seite 4/77