Connecting-Kit Coolserve (Option) - Knurr CoolServe Betriebsanleitung

CoolServe
Manual / Bedienungsanleitung
6.3

Connecting-Kit CoolServe (option)

To connect the CoolServe with chilled water from a pipe network we recommend, especially for
the Server Rack CS, the use of connecting kits.
CoolServe conneting kit consits of:
a) armoured hose with stainless steel covering, EPDM resistant against water and
antifreeze, hose connections nickel plated,
Temperature range:
Operating pressure:
Inside diameter
Connections:
Length:
b) Ball valve with fill and drainconnection ¾" female threat and possibility for
measurement of pressure and tempearture
connection size:
c) isolation and control valve with drain and bleed connection ¾" female threat and
measuring nipple for pressure and temperature
connection size:
CoolServe
0 - 110°C / 32 – 230°F
maximum 10 bar / 145 PSI
14 mm
1/2" male threat / 1/2" thread joint with elbow
1500 mm
1/2" female threat
1/2" female threat
Connection to
CoolServe
Chilled
water return
Chilled
water supply
figure connecting set
01_998_345_0_a
Connection to
pipework on site
page / Seite 22/77