Electrical Connection - Knurr CoolServe Betriebsanleitung

CoolServe
Manual / Bedienungsanleitung
5.5

Electrical connection

The standard wiring diagram is attached to this manual or it is project related enclosed to the unit.
The unit should only be connected by appropriately
qualified personnel (electrician). The personnel must ensure
that the server cabinet is electrically isolated for the
duration of the connection work and is secured against
unauthorised switch on.
Check whether voltage and frequency at installation site as well as
fuse ratings match the specifications on the rating plate.
Power supply connection is done by IEC 320 socket and plug.
To connect the unit to the power supply:
 See the wiring diagram for information on the connections to be made.
 Connect the supply cable to the device (IEC 320)
 Connect the supply cable to the mains
 Check the secure connection of the earth wire.
The unit's fans will rotate clockwise.
The status indicator on the RMS viewer will go green if running.
figure CoolServe rear side connections
CoolServe
intake grill
(block never)
01_998_345_0_a
power
power
connection A connection B
connection for
failure signals
page / Seite 17/77