Hazards Caused By Flying Parts; Hazards Caused By Entanglement; Hazards During Operation - Parkside PDMFW 15 A1 Originalbetriebsanleitung

Save all warnings and instructions for future
reference.
■ The user must evaluate the specific risks that
may arise due to different kinds of use .
■ Please ensure that you have read and understood
the safety instructions before fitting, operating,
repairing, servicing or replacing any accessories
and before working near the compressed air
tool . Failure to do this can result in serious
bodily injury .
■ The compressed air tool should only be set up,
adjusted or used by adequately qualified and
trained operators .
■ The compressed air tool may not be modified .
Modifications can reduce the effectiveness of
the safety measures and increase the risks for
the operator .
■ Never use damaged compressed air tools .
Maintain compressed air tools with care . Check
regularly whether moving parts function correctly
and do not jam; check whether any parts are
broken or damaged to an extent that the com-
pressed air tool will no longer operate correctly .
Check signs and labels for completeness and
readability . If damaged, have parts repaired or
replaced before using the compressed air tool .
Many accidents are caused by poorly main-
tained compressed air tools .

Hazards caused by flying parts

■ If a workpiece or accessory of the compressed
air tool breaks, parts can be flung out at high
speeds .
■ Always wear impact-resistant safety goggles
during operation, when replacing accessory
parts or during repair or maintenance of the
compressed air tool . The level of the required
protection must be evaluated separately for
each individual task .
■ You must ensure that the workpiece has been
securely fixed in place .
■ 4 │ GB │ IE │ NI
■ Ensure that sparks and fragments created during
work do not constitute any hazard .
■ Separate the compressed air tool from the com-
pressed air supply before replacing the attach-
ment or accessories or before you adjust the
settings, service or clean the tool .
■ Ensure that no dangers are created for other
persons either .

Hazards caused by entanglement

■ Be careful to avoid entanglement!
Suffocation, scalping and/or cut wounds can
occur if loose clothing, jewellery, necklaces, hair
or gloves are not kept away from the machine
and its accessories .

Hazards during operation

■ When using the compressed air tool, the opera-
tor's hands can be subject to hazards such as
cuts, grazing and heat . Wear suitable gloves to
protect your hands .
■ The operator and maintenance personnel must
be physically capable of handling the size,
weight and power of the compressed air tool .
■ Hold the compressed air tool correctly: be
ready to counteract any normal or sudden
movements – keep both hands ready .
■ Keep proper footing and balance at all times .
■ Prevent unintentional starting . If the air supply is
interrupted, switch off the compressed air tool
using the On/Off switch .
■ Use only the lubricants recommended by the
manufacturer .
PDMFW 15 A1