English - Johnson Pump F2P10-19 Bedienungsanleitung

ENGLISH

Self-priming, flexible impeller pump flange mounted to
DC motorn 12/24 V
Typical applications
Bilge pump, fuel oil transfer, deck
washing, fire pump, fresh water pump
etc.
Design features
Body:
Wear plate:
Impeller:
Shaft:
Shaft seal:
O-ring:
Connection: 1/2" hose or
Temperature: Liquid -20°C – +85°C.
Motor:
The motor is ignition protected
according to ISO 8846 (Small craft
- Electrical devices - Protection against
ignition of surrounding flammable
gases).
Type specification
Type
F2P10-19 12 V
24 V
F2P10-19 12 V
24 V
6
Thermoplastic
polyester (PTMT)
Stainless steel
Nitrile
Stainless steel
Nitrile
Nitrile
3/4" NH garden hose
Surrounding max +60°C
0.12 kW, 12/24 V DC
Part no Connection
10-24180-1 1/2" hose
10-24180-2 1/2" hose
10-24180-3 3/4" NH
garden hose
10-24180-4 3/4" NH
garden hose
Pressure and capacity data
(based on water at 20°C and at full
voltage of the motor)
Bar kPa ft
0 0 0
0.10 10 3.3
0.30 30 10.1
0.60 60 20.1
0.75 75 25.1
0.90 90 30.2
Fuse recommended
Installation and maintenance
Installation
Pump may be mounted in any position
without loss of efficiency; however, it is
suggested that the pump head be down
if vertical mounting is desired. Mount
motor as close as possible to power
source to obtain full voltage.
The pump should be installed so that
the motor is protected from rain or
wash down.
Electrical installation
The pump must be installed according
to ISO 10133 (Small craft - Electrical
system - Extra low voltage DC installa-
tion for continuous current). Note: The
fuse must be ignition protected.
See the wiring table below for
correct installation. Negative wire must
be black.
offered by Busse-Yachtshop.com
ENGLISH
Amp draw
l/min 12 V 24 V
USGPM
15 4.0 6.9 3.3
14.5 3.8 7.1 3.4
13.5 3.6 7.4 3.6
10.5 2.8 7.9 3.8
9.0 2.4 8.3 4.0
7.0 1.9 8.7 4.2
16 A 8 A