Accessories - Johnson Pump F2P10-19 Bedienungsanleitung

ENGLISH
Caution
Do not pump gasoline, solvents,
thinners, highly concentrated or
organic acids. If corrosive fluids must
be handled, pump life will be pro-
longed if flushed with water after each
use or after each work day.
Temperature
Max ambient temperature: +60°C.
The life of the impeller depends on
the temperature of liquid being
pumped. Temperatures between +5°C
and +60°C give normal life. Higher or
lower temperature will reduce the life.
Freezing weather
Drain unit by loosening the endcover.
Glycol based anti-freezes can be used
but do not use petroleum based anti-
freeze compounds.
Service instructions
(see page 21-22)
Disassembly
1. Back off the endcover screws (11),
remove the endcover/wearplate (4)
and O-ring (6).
2. Pull out the impeller (2) using a slip
joint plier or other suitable
implements.
3. Loosen and remove the screws (10)
holding the pump body to the motor.
4. Remove the retaining ring (9) and
the lip seal (7).
5. Do not disassemble the motor.
8
Assembly
1. Moisten the new lip seal with soapy
water (5% soft soap), mount the seal
with the lip facing towards the
impeller.
2. Lubricate the motor shaft with
vaseline of the like. Fit the body to
the motor.
3. Lubricate inside the pump body
where the impeller should be placed
with vaseline or the like. Also
lubricate the surface of the endcover.
4. Fit the impeller with a rotating
movement in the intended direction
of the pump rotation.
5. Lubricate the O-ring with vaseline or
the like and fit it in its position and
fasten the endcover/wearplate.
Impeller
The impeller is a very important
security device and should be replaced
every year with a Johnson Pump
originalimpeller.

Accessories

Vacuum switch 09-45053
• For automatic shut off operation.
• To prevent pump damage.
The vacuum switch works with all self-
priming impeller pumps and should be
used for e.g. bilge pumping/emptying
of tanks to prevent the pump from
running dry.
The vacuum switch automatically shuts
the pump off when the bilge/tank is
dry. With the switch fitted, you can
start the pump by remote push button
or manually by depressing lever on the
switch.
The switch is not
ignition protected.
offered by Busse-Yachtshop.com