Grohe 39354SH1 Kurzanleitung Seite 11

The electrical safety of the device is
only ensured when it is connected to a
properly installed ground conductor
system. This basic safety requirement
must be ensured. When in doubt,
have your electrical system checked
by a qualified electrician. The power
specifications (frequency and voltage)
shown on the nameplate of the device
must meet the specifications of the
mains line at the installation site, in
order to prevent damages to the
device.
It is recommended to power the
device with a regular wall socket (VDE
0701), as this facilitates easy
disconnecting from the power supply
in case of service works. If a wall
socket is not within reach or if a
permanent connection is planned, a
proper separation device for each
pole is required at the installation site.
A separating device within this
meaning is a wall switch where the
contact terminals are at least 3 mm
apart. This includes LS-switches,
fuses and contactors (EN 60 335).
The protective zones must
be assured in bathrooms.
If a power supply
connection is made in zone 2, then
the power supply to the Shower Toilet
can be established by a direct
connection, using a connector socket
IPX4 as permanent connection.
Do not use after taking a bath or
shower.
Do not pour water or cleaning agents
into or onto the toilet seat or the
remote control. It could cause electric
shock or fires.
WARNING
Risk of burns, electric shock, fires and/or
personal injury:
In devices that are delivered without
the connecting power line or when
replacing the damaged power line, as
special connector line must be
purchased from an authorized dealer.
The device must be disconnected
from the power supply for any and all
installation- and maintenance work
and for repairs.
This also applies in the event that you
find damages on the power supply
line or on the product itself.
Please ensure this by
– setting the fuses (LS switches) of
the electrical installation into the off
position or
– by completely removing the screw-in
fuses of the electrical installation or
– by completely pulling the power plug
(if any) out of the wall socket.
When doing so, do not pull on the
cord, but pull on the power plug (if
present) instead.
Check the temperature settings of the
water and the dryer air before each
use.
Set the air dryer temperature to the
lowest level if you intend to use this
feature for a prolonged period of time.
There is a risk of burns, if this feature
is used for a prolonged period of time
at high temperature settings. This
applies particularly to the following
populations: children, the elderly, ill
persons, persons with sensitive skin
and thermoregulatory dysfunctions,
the inebriated and overly tired people.
Do not use outdoors, including areas
with big vibrations, and do not operate
in a space where aerosol spray is
used or concentrated oxygen is being
administered. It may cause a
malfunction or loss of glossiness.
Make sure that no items or foreign
objects obstruct any openings (air
outlets, hoses, etc.). Remove any
obstructions immediately to prevent
possible hazards and damages.
11
GB