hanseatic 65M40M1-E11314A Gebrauchsanleitung Seite 63

Taking the oven door off its hinges
The oven door can be removed from its
hinges to enable easy cleaning of all areas
of the oven:
1. Open the oven door completely.
2. Fold the clips (d) on both sides all the way
forward. Use a screwdriver if necessary.
3. Only close the oven door so far that there
is still a gap of approx. 10 cm.
4. Lightly lift and guide the door forward out
of its hinges.
Putting the oven door back on its
hinges
1. Hold the door on an angle using both
hands.
2. Hook the hinges into the holes in the side
panels. The oven door must be level with
the oven.
3. Open the oven door completely.
4. Fold the clips (d) on both sides all the way
back again.
5. Close the door carefully. The door must
sit flush when closed. If the door does not
sit flush when closed or if there is a crack-
ing sound when closing it, the door is not
hung properly.
6. Correct the position of the hinges and
clips, if necessary, until the door opens
and closes smoothly again.
Cleaning the glass panes
The oven door contains two glass panes that
should occasionally be cleaned on both sides.
1. Take the oven door off its hinges (see
2. Place the oven door with the pane (e) on
3. Take both panes with one finger on each
(d)
4. Take the pane (g) out of the oven door
5. Clean both panes with warm clean water.
6. Dry the panes thoroughly.
7. Return the pane (g) back into the oven
8. Replace the oven door (see chapter "Put-
Cleaning
chapter "Taking the oven door off its
hinges").
a soft base.
side in the gap and on both sides push
the rear clamp (f) forward so that the pane
(g) is released from the clamp brackets.
door and push it down firmly with the
clamps (f).
ting the oven door back on its hinges").
Page GB-15
(g)
(f)
(e)