Technical Data - Husqvarna 129 C Bedienungsanweisung

T T o adjust the idle speed
• Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
• Adjust the idle speed with the idle adjustment screw
T (P P icture 42) which is identified with "T" mark.
• The idle speed is correct when the engine operates
smoothly in all positions. The idle speed must be
below the speed when the cutting attachment starts
to turn.
1. Turn the idle adjustment screw clockwise until the
cutting attachment starts to turn.
2. Turn the idle adjustment screw counterclockwise
until the cutting attachment stops.
To do maintenance on the spark
arrester screen
Use a wire brush to clean the spark arrester screen
(P P icture 43).
To clean the cooling system
Clean the parts of the cooling system ( ( Picture 44) with a
brush.
To examine the spark plug
CAUTION! Use the recommended spark
plug. Make sure that the replacement is the
same as the manufacturer supplied part. An
incorrect spark plug can cause damage to
the product.
1. Examine the spark plug when:
a) the engine is low on power.
b) the engine is not easy to start.
c) the engine does not operate correctly at idle
speed.
2. If, the engine is not easy to start or operate, examine
the spark plug for unwanted materials. To decrease
the risk of unwanted material on the spark plug
electrodes:
a) make sure that the idle speed is correctly
adjusted.
b) make sure that the fuel mixture is correct.
c) make sure that the air filter is clean.
3. Clean the spark plug if it is dirty. Examine that the
electrode gap is correct (P P icture 45).
Engine Specifications
155 - 003 -
4. Replace the spark plug when it is necessary.
To apply grease to the two-piece shaft
• Apply grease to the end of the drive shaft after each
30 hours of operation (P P icture 46).
To do the maintenance to the air filter
To clean the air filter
1. Remove the air filter cover and remove the air filter
(P P icture 47).
2. Clean the air filter with warm soap water. Make sure
that the air filter is dry before you install it.
3. Replace the air filter if it is too dirty to fully clean it.
Always replace a damaged air filter.
4. If your product has a foam air filter, apply air filter oil.
Only apply air filter oil to a foam filter. Do not apply
oil to a felt filter.
To apply air filter oil to the air filter
1. Remove the air filter cover and remove the air filter
(P P icture 47).
2. Put the air filter in a plastic bag.
3. Put the air filter oil in the plastic bag (P P icture 48).
4. Push the plastic bag to make sure the oil supplies
equally across the air filter.
5. Push on the air filter, while in the bag, to remove the
air filter oil that is not necessary. Remove the air
filter from the bag.
6. Install the air filter.
To add grease to the bevel gear
Make sure that the bevel gear is filled 3/4 full with bevel
gear grease (P P icture 49).

TECHNICAL DATA

unit
CAUTION! Always use special air filter oil on
foam air filters. Do not use other types of oil.
WARNING! Do not get oil on your body.
1 1 29C
(A05328CCHV) (A05328CSHV)
129L 129LK
(A05328CSHV)
13