Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
8
6
7
1
POWER IN
Blue power input socket for power supply to the device. A suitable power cable is included.
2
POWER OUT
White power output socket for the power supply of additional CAMEO spotlights. Ensure that the total current consumption of all connected
devices does not exceed the value specified on the device in amperes (A).
3
FUSE
Fuse holder with fuse F3AL/250 V (5 x 20 mm). IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of
repeated fuse failure, please contact an authorised service centre.
4
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
5
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
6
LC DISPLAY
The illuminated LCD display shows the currently activated mode (main display), the menu items in the selection menu and the numerical
value or operating mode in certain menu items. If there is no input for approx. 30 seconds, the display automatically returns to the main
display. If there is no control signal at the DMX input, the DMX address will flash in the display in DMX mode or "SLAVE" in slave mode.
7
CONTROL BUTTONS
MODE – press MODE to access the selection menu. Each repeated press takes you up one level in the menu structure to the main display.
UP and DOWN – select the individual menu items in the selection menu (DMX address, operating mode, etc.) and in the sub-menus and
change the value in a menu item, such as the DMX address.
ENTER – press ENTER to access the selection menu and submenu level where you can make changes to the value and status. Confirm
value or status changes by pressing ENTER.
8
MIC
Microphone for music control in stand-alone and DMX modes.
5
4
2
1
3
5
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
