Advanced Settings; Device Information - Cameo THUNDERWASH 600 RGBW Bedienungsanleitung

ADVANCED SETTINGS

Press MODE to access the selection menu (System Settings). Using the UP and DOWN controls, select the menu item "Advanced Settings"
(dark background) and confirm with ENTER. This will take you to the submenu for editing the following submenu items (see table, selection
with UP and DOWN, confirm with ENTER, change status/value with UP and DOWN, confirm with ENTER):
System Settings Advanced Settings
DMX Address 001 Display Invert
DMX Mode 7CH_2 Display
Stand Alone Display Contrast
Slave Mode Off/On DMX Fail
Advanced Settings LED Calibration
System Info Factory Reset
Advanced settings (bold = factory setting)
Display Invert = Display rotation
Display = Display lighting
Display = 3-stage contrast setting
Contrast
DMX Fail = Operating status in the
event of
DMX signal interruption
LED Calibra- = Cross-mode calibration of the
tion R, G, B and W brightness
Factory Reset = Reset to factory settings

DEVICE INFORMATION

Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "System Info" (dark background) and
confirm with ENTER.
System Settings System Info
DMX Address 001 Version
DMX Mode 7CH_2 Temperature
Stand Alone Hours
Slave Mode Off/On
Advanced Settings
System Info
This will take you to the sub-menu for displaying device information. Use the UP and DOWN keys again to select the desired parameter and
then retrieve and/or configure with ENTER.
System Info (bold = factory setting)
Version = Displays device software version
Temperature = Displays temperature of LED unit
Hours = Operating time display
8
No/Yes
30s/On
0/50/100
Black/Hold
No
Yes
On
30s
0
50
100
Hold
Black
Red 000–255
Green 000–255
Blue 000–255
White 000–255
No
Yes
V1.x
Temperature
Unit
xxxxx
No display rotation
Rotate display by 180°
(e.g. for overhead installation)
on permanently
Deactivates after approximately 30 seconds of inactivity
low contrast
medium contrast
high contrast
Last command is retained
Activates blackout
calibrate red
calibrate green
calibrate blue
calibrate white
Do not perform reset
Perform reset
xx°C/xx°F
°C/°F Display in degrees Celsius or degrees
Fahrenheit
Displays the operating time of the spotlight
in hours