Manual Adjustment; Electronic Adjustment - AEG GS60AV222 Benutzerinformation

2) Do not use salt at this level.
You must adjust the water soft-
ener manually and electronically.

Manual adjustment

Electronic adjustment

1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
'Setting and starting a programme'.
2. Press and hold, at the same time,
button and button
the indicators of buttons
and
3.
Press button
• The indicators of buttons
and go off.
6.2 Filling the salt container
until
,
start to flash.
.
Turn the water hardness dial to the posi-
tion 1 or 2.
•
The indicator of button
tinues to flash.
• The current setting of the water
softener is indicated by intermit-
tent acoustic signals and the flash-
ing of the end indicator.
– E.g. 5 acoustic signals and 5
flashes + pause + 5 acoustic sig-
nals and 5 flashes = level 5.
4.
Press button
to change the setting. Each time you
press the button you select the next
level.
5. Deactivate the appliance to confirm
the setting.
1. Turn the cap counterclockwise and
open the salt container.
2.
Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
ENGLISH
57
con-
again and again