Chicco Classic Gebrauchsanleitung Seite 17

2.1.2 Modes of use - Switching on and
Adjustment.
The baby unit must be positioned about
1 - 1.5 metres from the child, on a flat,
stable surface and with the microphone
(4) directed toward the child.
Caution: the transmitter, the batteries,
the mains adapter and its power cord
must be kept out of reach of children.
-Baby unit On/Off button (2).
Pressing this button turns on the baby
unit and the power indicator light (3)
lights up green. Pressing the button (2)
again turns off the baby unit and the
power indicator light (3) goes off.
Selecting the transmission channel.
Select transmission channel 1 or 2 using
the channel selector switch (6), making
sure you have selected the same chan-
nel on both units. The presence of two
channels is intended to reduce the pos-
sibility of any interference or disturbance
caused by other units in the vicinity.
Important: always make sure that you
select the same channel on both units.
- Voice activation or continuous trans-
mission selector (5).
The parent unit can operate in con-
tinuous mode (selector set to OFF) or
in voice-activated mode (selector set to
ON). In voice activation mode, the re-
production of any sounds emitted from
the child that are below the factory set
default voice activation threshold are
interrupted, while all sounds above the
threshold are reproduced.
2.2 Parent unit:
2.2.1 Power:
Caution
- Do not leave mains adapters plugged
into the socket when devices are not in
use and/or not connected to the mains
adapters (1).
2.2.2 Modes of use
-Parent unit on/off switch (2).
Pressing this button turns on the par-
ent unit and the power indicator light
(3) lights up green. Pressing the button
again turns off the parent unit and the
power indicator light (3) goes off.
- Selecting the transmission channel.
Select transmission channel 1 or 2 using
the channel selector switch (4), making
sure you have selected the same chan-
nel on both units. The presence of two
channels is intended to reduce the pos-
sibility of any interference or disturbance
caused by other units in the vicinity.
Important: always make sure that you
select the same channel on both units.
- Adjusting the speaker volume.
To adjust the volume, turn the volume
control dial (5) located on the parent
unit.
Turning the dial as far downwards as it
will go turns off the volume. Turning the
dial as far upwards as it will go selects
the maximum volume.
3. Installation and replacement of
alkaline batteries in the baby unit
and the rechargeable batteries in the
parent unit
Warnings: these operations
should only be performed by an adult
Caution: RECOMMENDA-
TIONS FOR BATTERY USE
- Use only 1.5 V AAA alkaline batter-
ies (not supplied) for the baby unit and
NiMH rechargeable batteries for the par-
ent unit with code 20256300100.
- Always remove the 1.5 V AAA alkaline
batteries (not supplied) and/or the re-
17