Casualplay KANGUR FIX SAFE TECH Anweisungen Seite 23

• Fit the support leg onto the safety seat.
• Extract the isofix connectors pressing the button on the front (fig.11).
• Place the safety seat on the vehicle seat, press the child restraint
system, leaning against the front of it, against the vehicle seat.
• Fasten both connectors to the vehicle anchors (fig.12).
NOTE: Make sure that both connectors are fastened correctly.
• Press the safety seat against the vehicle seat until they are backrest
against backrest (fig.13).
• Adjust the height of the support leg.
WARNING: Make sure that the support leg is in contact with the floor of the
car. It must not be suspended in mid-air or resting against any other object.
• Loosen the safety harness. Press the harness adjustment button while
pulling the harness (fig.1).
• Unfasten the harness buckle and separate the two sides (fig.14).
• Place the child in the restraint system.
• Adjust the height of the headrest and fit the harness on the child at the
correct height.
• Fasten the harness by bringing the two parts of the chest straps
together and inserting them in the female part of the buckle. Then
press both until they click fastened (fig.15).
• Place the backrest in the required reclining position.
• Lastly, pull the harness adjustment strap until it fits the child correctly. (fig.16).
REmOving ThE SAfETy SEAT
• Unfasten the harness buckle, by pressing the red button in the middle
of the buckle.
• Take the child out of the restraint system and fasten the buckle again.
• Release the isofix connectors, by pulling the button on the front of the
base (fig.17).
• Take the seat out of the vehicle, and remove the support leg (fig.18).
inSTALLing ThE SAfETy SEAT wiTh ThE SEAT BELT AnD SUPPORT LEg
• Conceal the isofix connectors on the safety seat, by pressing them
inside the frame (fig.19).
• Fit the support leg onto the safety seat.
• Place the safety seat on the vehicle seat, press the child restraint
21