Explosive Atmosphere; Slipping; Tripping; Circuit Faults - ISA STRATOS Benutzer- Und Instandhaltungshandbuch

6.7

EXPLOSIVE ATMOSPHERE

The equipment must not be located in an area classified as an explosion risk
as per 199/92/EC such as:
Zone 0
An area in which there is a permanent, long-lasting or frequently explosive atmosphere made up of a mixture of air and
flammable substances in the form of gases, fumes or steam.
Zone 1
An area in which the formation of an explosive atmosphere, made up of a mixture of air and flammable substances in
the form of gases, fumes or steam is occasionally probable during normal activities.
Zone 20
An area in which there is a permanent, long-lasting or frequently explosive atmosphere in the form of clouds of
combustible dust in the air.
Zone 21
An area in which the formation of an explosive atmosphere in the form of clouds of combustible dust is occasionally
probable during normal activities.
6.8

SLIPPING

6.9

TRIPPING

6.10

CIRCUIT FAULTS

Owing to potential faults, safety circuits may become less effective, which results in lower safety levels. You should
check the operational condition of the appliance devices regularly.
6.11 WARNING SIGNS
The appliance is fitted with warning danger, warning and obligation signs defined in agreement with the Standard relative to
the graphical signs to be used on equipment. These signs are located where they are clearly visible.
ATTENTION
Any warning plates on the appliance must not be removed.
The user is responsible for replacing warning signs that, owing to wear, become unreadable.
6.13

FALLING OBJECTS

The positioning of the cabinet display parts (where present) of the equipment (i.e. counters, rods and hooks, etc.),
as well as the arrangement of the products inside the cabinet can be the source of potential hazards if not properly
performed. Follow the positioning instructions described in this Manual before you place products inside the cabinet,
check that the counters are properly fastened, as also the hooks, etc. Do not exceed the maximum load limit. Do not
exceed the maximum load limit. Do not position tilted product on the counters if they are not held in place by their
stoppers.
6.13

COOLING

During different operations to perform on the counter, such as cleaning or loading goods, it is necessary to handle
products and/or counter parts at a low temperature with the risk of "cold injury" for the operators and/or accidental
slipping hazard. Follow the safety regulations in the place where the cabinet is installed; more specifically, be sure to
always use correct PPE (especially gloves).
6.14 FOODSTUFFS SAFETY
Therefrigerator cabinet described herein is meant to be used to display packaged products. Assuch, it is not designed
for direct contact between the foodstuffs and display surfaces. If the foodstuffs do accidentally make contact with the
surfaces and for a rather long time, the product may be contaminated. Follow the guidelines on how to use the cabinet.
If a product package breaks, remove it from the cabinet and clean, if necessary.
428000939100
DANGER
Any leaks in the areas surrounding the appliance may cause personnel to slip. Check that there are
no leaks and keep these areas clean at all times.
DANGER
Generally untidy deposits of material may constitute a trip hazard and a total or partial obstruction
of emergency exit routes. You should ensure that operating and transit areas and escape routes are
free from obstacles in compliance with current law.
(IF ANY)
(PACKAGED PRODUCTS)
STRATOS
55
EN