Remote Control Ir - EuroLite LED KLS PARty Bedienungsanleitung

Remote control IR-30

When actuating a button, always direct the remote control towards the sensor. There must be no obstacles
between remote control and the sensor.
A1
DMX
A2 A3 A4
A5 A6 A7
DMX
COLOR
SPEED
SEN
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
Button Function
Blackout on/off
DMX-mode
DMX
Address setting via DMX (+)/(‒)
Presest colors
A1
Color/color combination choice via COLOR
Switching colors
A2
Program speed via
Fading colors
A3
Program speed via
Sound control
A4 For program choice press A4 repeatedly
Microphone sensitivity via
Strobe effect
A5
Flash rate
Auto program
A6
Program speed via
Chaser program
A7
Program speed via
DMX - / +
DMX address setting via (+)/(‒)
Choice of color/color combination under A1
COLOR - / +
Setting via (+)/(‒)
Program speed under
SPEED - / +
Setting via (+)/(‒)
SEN Microphone sensitivity; Levels
26/32
SPEED
SPEED
SEN
via SPEED
SPEED
SPEED
A2, A3, A5, A6, A7;
1-9; Setting via (+)/(‒)
00118185, Version 1.1