Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
Fixing to a truss
The light set can be fixed to a truss using two TPC-hooks with M10 screw or to a similar rigging structure.
The device must never be fixed swinging freely in the room.
1.
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2.
Block access below the work area and work from a stable platform when installing the device.
3.
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the Accessories section for a list of suitable rigging hardware.
4.
In each case, put the head of an M10 screw on the upper side of the control unit and, together with the
TCP-hooks, screw them down as plane as possible onto the control unit.
5.
Suspend the TPC-hooks in the truss and tighten the fixation screws
6.
Secure the device with a safety bond or other secondary attachment. This secondary safety
attachment must be sufficiently dimensioned in accordance with the latest industrial safety regulations
and constructed in a way that no part of the installation can fall down if the main attachment fails. An
appropriate eyelet is mounted on the device for fixation of the safety rope. Fasten the safety rope in
such a way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm.
7.
After installation, the device requires inspections periodically to prevent the possibility of rot,
deformation and looseness.
Mounting on a speaker stand
1. On the speaker system, first loosen the fixation screws of the legs. Pull out the legs until the cross
struts stand at a 90° angle to the legs. Tighten the fixation screws of the legs.
2. Loosen the knurled head screw on the stand sleeve of the device and install the fixture on the stand
via the sleeve. Tighten the fixation screw. Suitable stands can be found under Accessories.
3. Caution! The load has to be installed in a balanced way. The carrying capacity of the speaker system
must never be exceeded. The speaker system must be set up in a stable way. Make sure all fixation
screws fit tightly.
23/32
00118185, Version 1.1
Werbung
Inhaltsverzeichnis
