Tool Identification; Main Components; Technical Data - FAR RAC 180 Bedienungsanleitung

RAC 180

TOOL IDENTIFICATION

The riveting tool RAC 180 is identified by a label showing the
name and the address of the manufacturer and model.
If any service is requested please make reference to data
shown on the label.
GENERAL NOTES AND USE
The tool must be used for rivets diam. 2,4 - 6 mm only.
Diam 6 mm only in aluminium.
The RAC 180 oil pneumatic system assures more power than
the pneumatic system used for other models. That means
a reduction in the problems due to the wear and tear of the
components, therefore, there will be an increase in reliability.
The technicai solutions adopted reduce the dimensions and the
weight of the tooi which, for these reasons, make it very handy.
The possibilities of leakage from the oil-dynamic system, are
eliminated by some sealed gaskets, which solve this problem.
Revision - 09
Name and address
of manufacturer
Model
GB

MAIN COMPONENTS

A) ................................................................................. Nozzle
B) ............................................................Balancer connection
C) .................................................................... Nails container
D) .......................................................................Suction valve
E) ....................................................... Tensile strenght button
F) ........................................................................Oil tank plug
G) ................................................ Compressed air connection
H) ............................................. Head carring nozzle ø 22 mm
I) ................................................................ Protection bottom
A
57
Ø 22
D
E
302
G

TECHNICAL DATA

• Working pressure ......................................................6 BAR
• Min. int. diam. of the compressed
air feeding hose ................................... min. diam = 8 mm
• Air consumption per cycle ........................................4,8 Lt.
•
Maximum force
• Weight .................................................................. 2,070 Kg
• Working temperature .............................................-5°/+50°
• Root mean square in total acceleration frequency (Ac)
to which the arms are subjected. ...................... 5,7 m/sec2
•
A-weighted emission sound pressure level
•
Peak C-weighted instantaneous sound pressure
•
A-weighted emission sound pressure
AIR FEED
The air feed must be free from foreign bodies and humidity
in order to protect the tool from premature wear and tear of
the components in movement, therefore we suggest to use a
lubrificator group for compressed air.
Date 03-2010
305
B
H
F
Ø 130
.............................................
...........................
C
Ø 60
I
6 BAR -10791 N
...............
75,5 dBA
.......
<130 dBC
93 dBA
9