Commissioning - Berker Knx Touch Control Bedienungs- Und Montageanleitung

(16)
(11)
(16) Dismantling opening

5.2 Commissioning

Systemlink – Loading the physical address and application software
The device is connected to the KNX bus and auxiliary voltage.
The physical address is only ever assigned for one device. Only one de-
vice can ever be in programming mode.
„ Switch on bus voltage
„ Switch on auxiliary voltage.
„ Press programming button
The programming LED
Or via the menu:
„ Press control surface
07:22
The display changes to the menu
„ Then select
„ Switch control surface for
The device is in programming mode.
„ Load the physical address into the device.
The programming LED goes out. In the display, the message
automatically.
Seite 6 Seite 7
„ Load application software into the device.
„ Stick enclosed stickers on the back of the device and note down the phys-
ical address.
Figure 12: Dismantling
(5) at the back of the device.
(5) lights up.
in the top display row (8).
- -
–
appears briefly. The device is restarted
.
in succession.
.
ON
z
39