Berker KNX Touch Control Bedienungs- Und Montageanleitung Seite 30

Wecker
Einstellungen System
z
Wecker
EIN
The display area of the activated value is framed by a light border at the
Weckzeit
bottom and to the right.
Sprache der
+
–
„ With / change the respective setpoint.
editierbaren Texte
07 : 45
„ In the same way, change the end time
„ Activate the button for each weekday on which this function should be
Tastenton
executed within the defined time period.
The active buttons of the weekdays are displayed in light grey.
„ With confirm the entry.
The display returns to the previous menu level.
If the entries are not confirmed, with
menu level without saving. Using
previously as
Settings
Settings System
30
Wecker
EIN
Weckzeit
+
07 : 45
Einstellungen
Sprache
System
Bildschirm
without saving.
System
Cleaning mode
Timer
Ventilation 2 Ventilation 3
P 02 12:00 to 12:05 P 03 18:00 bis 18:05
Mon Tue Wed Thu Fri Sat Sun Mon Tue Wed Thu Fri Sat Sun
Night low. Mon-Fri Night low. Sat-Sun
P 04 22:00 bis 06:00 P 05 23:30 bis 09:00
Mon Tue Wed Thu Fri Sat Sun Mon Tue Wed Thu Fri
Figure 6: Changing a time period
.
Einstellungen System
System
Sprache
System editierbaren Texte
Sprache der
editierbaren Texte
Bildschirm
Tastenton
the display returns to the previous
the display returns to a page preset
Settings System
Alarm
Alarm clock
Settings System Timer
–
from
–
to
Mon Tue
Sat Sun
Sprache der
Tastenton
Timer
Service
P 02
+
12 : 00
+
12 : 05
Wed Thu Fri Sat Sun