Ottobock 4R160-1 Gebrauchsanweisung Seite 9

5 Indication
For transfemoral amputees.
The Delrin KISS Kit 4R160=1 is suitable for contracted residual limbs. It needs
an additional socket adapter to connect to the modular system. Furthermore,
it is used with carbon frames in conjunction with Thermolyn soft.
The 4-Hole-Endoskeletal KISS Kit 4R160=2 is suitable for normal residual
limb positions and for sockets laminated without an inner socket. It provides
a direct connection to the modular system.
6 Fabrication
CAUTION
Incorrect alignment or assembly
Injuries due to fall resulting from damaged prosthesis components
• Observe the alignment and assembly instructions.
The fabrication of a transfemoral prosthesis with the KISS system is described
in the technical information 646T2=6.5GB.
Following a short summary is written:
Prepare the plaster positive and attach the distal base to the plaster positive
(Fig. 3). Make sure that the strap exit slot points towards the desired orientation
(commonly ventral). Clean away excess plaster and let set until dry.
Afterwards go on with the choosen system:
• Delrin KISS Kit 4R160=1: Fill in all undercuts with putty, including the tab
area to be able to easily remove the flexible inner socket from the carbon
frame (Fig. 4). Isolate the thread in the tab with Plastaband 636K8=*. Pull
a nylon sock 99B25 over the flexible inner socket. Afterwards, laminate as
usual and apply the connection adapter.
• 4-Hole-Endoskeletal KISS Kit 4R160=2: Isolate the distal base and pull
over a PVA bag according to technical information 646T2=6.5GB (Fig. 5).
For connecting with the modular system use the KISS Lamination Kit
4R161 (Fig. 6). Integrate the lamination kit into the lamination (Fig. 7).
A reinforcement recommendation is described in the technical information
646T2=6.5GB. Finally, place the rubber plate on the liner and fix it. Trim
the straps as needed (Fig. 8).
Ottobock | 9