Changing The Diamonds - Husqvarna PG 530 Bedienungsanleitung

Changing the diamonds

As different applications require different selections of
diamond tools, there will be many occasions when the
grinding discs need to be changed.
Following is a guide for this procedure.
Preparation
1. Ensure STOP/RUN switch is in STOP position and
the power-plug disconnected as unintentional start-
ing of machine while changing discs can result in
serious injury.
2. Have a set of gloves ready, as diamonds can get
very hot during dry grinding applications.
Changing
1. Set handle in upright position (illustrated right).
2. Pull back on handle to lift grinding head off the
ground.
4. Lay machine back on the ground.
5. Put on gloves.
6. Remove grinding disc by slightly rotating disc and
then pull off (direction that the discs will need to be
rotated will depend on the direction the machine
was last running).
7. Check to ensure all head locks/shear pins are tight.
8. Once new diamonds have been attached, reverse
procedure to lower machine to ground.
9. As new diamonds may be a different height to set
being previously used, re-adjust skirt to ensure
good seal is established with the fl oor.
Changing the diamonds
11
English -