Husqvarna PG 530 Bedienungsanleitung Seite 19

Full and half sets of diamonds
By changing the way the diamonds are set-up on the
diamond holder discs, an operator can signifi cantly ef-
fect the performance of the machine and therefore, the
fi nished product.
HALF-SET OF DIAMONDS
When the diamonds are set-up as a half-set, they tend
to follow the surface of the fl oor. Similar to a tripod for a
camera, which can be placed on an uneven surface and
yet still fi nd a stable footing.
The half-set diamond confi guration should only be used
when a fl at fl oor fi nish is not required.
FULL-SET OF DIAMONDS
When the diamonds are set-up as a full-set, they tend
not to follow the surface of the fl oor. If the fl oor has un-
dulations, the machine will grind the high areas yet miss
the low spots (unless the high areas are ground down
fi rst).
The full-set diamond confi guration should be used when
a fl at fl oor fi nish is desired.
The below table gives some examples of possible ap-
plications for the two arrangements:
Application
Ceramic tile adhesive removal
Carpet glue removal
Epoxy paint removal
Vinyl adhesive removal
Rain damaged concrete
Smoothen exposed aggregate
Lippage removal in terrazzo/stone tiles
Surface polishing of concrete fl oors
Grinding to expose aggregate in concrete polishing application
Remove lippage from terrazzo/natural stone tiles
Flatten undulations in concrete fl oors
Re-polish fl oors that have been ground before
Diamond selection
Full set is best Half set is best
X
X
X
X
X
X
X
X
X
X
X
X
19
English -