Error Messages - Sony BVP-9500WSP Bedienungsanleitung

Display on the Viewfinder Screen

Error Messages

If an error occurs during automatic adjustments, an
error message appears on a viewfinder screen. Take
following measures according to the displayed
message.
When the automatic adjustment finishes normally,
"Completed" appears on a viewfinder screen.
OVER FLOW
The adjusted value overflowed the adjustable range.
Check whether the settings on the camera are correct
or not. If they are correct, adjustments of the internal
boards are necessary.
For details on the adjustments of the internal boards,
consult your Sony service representative.
LOW LEVEL
The video signal level was too low for white balance
adjustment, and the white balance could not be
adjusted.
Raise the signal level with one of the following
methods:
• Use brighter illumination.
• Open the lens iris.
• Raise the gain of the video signal.
OVER LEVEL
The video signal level was too high for white balance
adjustment, and the white balance could not be
adjusted.
Decrease the signal level with one of the following
methods:
• Use darker illumination.
• Close the lens iris.
• Decrease the gain of the video signal.
TIME OUT
Automatic adjustment did not finish within a specified
period.
Check whether the settings on the camera are correct
or not. If they are correct, adjustments of the internal
boards are necessary.
For details on the adjustments of the internal boards,
consult your Sony service representative.
20(E)
NOT CLOSE
The lens did not close for black balance adjustment.
Check the lens iris.
BREAK
The automatic adjustment was interrupted with the
BREAK command.
This is not an error.