Front Panel - Sony BVP-9500WSP Bedienungsanleitung

Front Panel

VTR
START
SHUTTER
OFF +48V WHT
OFF
ON
LENS
BLK
SEL
5 SHUTTER switch
4 VTR START button
3 LENS connector
2 Microphone power switch
1 MIC 1 connector
1 MIC 1 (microphone channel 1) connector (3-pin)
Accepts the signal of microphone channel 1.
Normally, connect the microphone supplied with the
optional BVF-10/10CE, BVF-C10W or BVF-20W/
20WCE Viewfinder.
2 Microphone power switch
For the microphone connected to the MIC-1 connector.
ON: When the microphone supplied with the optional
BVF-10/10CE, BVF-C10W or BVF-20W/20WCE
Viewfinder is connected, power as shown below is
supplied to the microphone.
When a CA-570/570P/550/550P is connected,
power of +12 V is supplied.
When a CA-950/950P is connected, power of +48
V is supplied if the external mic/power supply
mode switch on the CA-950/950P is set to +48 V,
or power of +12 V is supplied if the switch is set to
OFF.
OFF: When the connected microphone requires no
external power.
3 LENS connector (12-pin)
Connect a lens cable.
AUTO MIC1
W/B BAL LEVEL
7 MIC 1 LEVEL control
6 AUTO W/B BAL switch
4 VTR START button
When the Camera Control Unit (CCU) is connected
using the optional camera adaptor, the audio signal of
intercom 1 is sent to the CCU while this button is kept
pressed. The function of this button can be changed
with the BVP-9500 Setup display shown on the
viewfinder screen so that the audio signal of intercom
1 or 2 or the return video 2 signal is sent to the CCU
while this button is kept pressed.
For menu operations, see "Display on the Viewfinder
Screen."
When a VTR is connected using the CA-553/553P,
pressing this button starts recording, and pressing
again stops recording. It is the same function as with
the VTR button on the lens.
5 SHUTTER switch
OFF: An electronic shutter does not function.
ON: An electronic shutter is activated.
SEL: The shutter speed and shutter mode change each
time the switch is set to this position.
For details, refer to the System Manual for the BVP-900-
series.
6 AUTO W/B BAL (automatic white balance/
black balance adjustment) switch
Adjusts the white balance and black balance
automatically.
WHT: The white balance is automatically adjusted.
When the WHITE switch on the side of the camera
is set to A or B, the adjusted value is stored in
memory A or B.
BLK: The black balance is automatically adjusted.
The black set is simultaneously adjusted.
Note
The SHUTTER and AUTO W/B BAL switches do not
function when the camera is connected to the camera
control unit (CCU).
7 MIC 1 LEVEL (microphone 1 level) control
When a VTR is connected using the optional camera
adaptor, the microphone 1 audio level can be adjusted
by turning this control.
When the CA-950/950P/570/570P Camera Adaptor is
used and the LEVEL/MIC switch on the rear panel of
the camera adaptor is set to FRONT/OFF, adjust the
sound volume of the intercom with this control.
You can also turn on/off the intercom 1 microphone by
pressing this control.
When the DISPLAY switch on the side panel of this
camera is set to MENU, turn this control to select a
menu item and press it to register the selection.
For menu operations, see "Display on the Viewfinder
Screen."
9(E)