Sony BVP-9500WSP Bedienungsanleitung Seite 47

VF Setup 3 display (stand-alone operation)
Test Out Select and Monitor Select are items for stand-
alone operation.
Using these menu items, you can select control mode
and signal for monitor output from the TEST OUT
connector of the camera.
* VF Setup 3 *
cMix VF
VF Detail
VF Detail Level :0
VF Y Fix
Test Out Select :REM
Monitor Select
Test Out Select appears only when the RM-B150,
RCP-700-series panel or MSU-750/700/700A is
connected to the REMOTE connector of the camera
with the CCU-900/900P/700A/700AP/550A/550AP
not connected.
Monitor Select appears when Test Out Select is set to
REM,
To set control mode for the TEST OUT signal
1
Set the cursor to Test Out Select by turning the
MIC 1 LEVEL control.
The REM or LOC indication starts blinking.
2
Press the MIC 1 LEVEL control.
Each time you press the control, REM and LOC
are cyclically selected.
When the item is set to LOC (local), the TEST
OUT signal can be selected using the TEST OUT
selector in the side switch box of the camera.
When the item is set to REM (remote), the
signal select buttons of the camera are disabled.
The TEST OUT signal currently selected is
displayed for Monitor Select.
The signal can be selected using the MONITOR
SELECT button on the connected MSU-750/700/
700A or the RCP-700-series panel or on the
Monitor Select menu.
:OFF
:OFF
:OFF
:ENC
To select the TEST OUT signal with Monitor
Select
1
Set the cursor to Monitor Select by turning the
MIC 1 LEVEL control.
The signal indication starts blinking.
2
Press the MIC 1 LEVEL control.
Each time you press the control, Y, R, G, and B are
cyclically selected.
When the selection is completed
Press the ENTER/CANCEL switch toward CANCEL
to return to the Operation menu.
BVP-9500 Setup display
(stand-alone operation)
For stand-alone operation, adjust the phase with an
external sync signal.
* BVP-9500 Setup *
cLens VTR S/S
Front VTR S/S
Select Lens
H Phase Coarse : 0
H Phase Fine
SC Phase
Name :A10x4.8
No:1 EX1.0 F1.8
1 VTR switch on the lens
2 VTR switch on the front of the camera
3 Lens file number
4 Phase adjustments with an external sync signal
5 Contents of the selected file
Name: Lens name
No. Lens file number
EX: Lens extender value
F: F number
For adjusting the H-phase roughly
1
Turn the MIC 1 LEVEL control to place the cursor
to H Phase Coarse, and push the control.
The figure starts blinking.
2
Turn the MIC 1 LEVEL control to adjust the
phase.
3
Push the MIC 1 LEVEL control.
The figure stops blinking and setting is completed.
: RET2
1
: RET2
2
: 1
3
: 0
4
: 0
5
15(E)