Transmitter Mounting Details - ABB TB82PH Bedienungsanleitung

ABB

TRANSMITTER MOUNTING DETAILS

Warning.
For installation in Hazardous
Areas, i.e. areas with danger
of fire and/or explosion,
irrespective of the protection
mode used, the installation
must carried out in accordance
with local authority regulations.
Ensure also that the tem-
perature of the transmitter
does not exceed the value
indicated in the
Approval Label.
Note.
When mounting the trans-
mitter, choose a location that
has ample clearance for the
removal of the front bezel and
rear cover. The location
should provide easy access
for maintenance procedures
and not be in a highly cor-
rosive environment. Excessive
mechanical vibrations
shocks as well as relay and
power switches should not be
in the immediate area. Signal
wiring should not be placed in
conduit or open trays that
contain power wiring for heavy
electrical equipment.
Caution.
Besides the
precautions for storage and
handling of electronic equip-
ment, the transmitter contains
static sensitive devices. Since
semiconductors can
damaged by the
discharge of static electricity,
avoid contact with terminal
block conductors and elec-
tronic components on
circuit board.
TB82PH-ATEX-EN-B
5/16" U-BOLT (2)
Agency
FASTENERS FOR
WALL (SUPPLIED BY
OTHERS)
and
WALL
3/8" NUT (8)
PIPE
normal
MOUNT
BRACKET
be
WALL
direct
the
3/8" X 5/8"
BOLT (4)
TB82PH ATEX Product Instruction Manual
PIPE
MOUNT
LOCKWASHER (4)
BRACKET
FLATWASHER (4)
Pipe
3/8" X 5/8"
LOCKWASHER (4)
5/16"
BOLT (4)
FLATWASHER (4)
Figure 3 – Pipe Mounting Detail
TOP VIEW
S.S. HINGE
3/8" X 3/4"
BOLT (8)
"L" BRACKET
3/8"
LOCKWASHER (8)
3/8"
FLATWASHER (8)
Figure 4 – Hinge Mounting Detail
3/8"
FLATWASHER (4)
FASTENERS FOR WALL
(SUPPLIED BY OTHERS)
3/8"
LOCKWASHER (4)
Figure 5 – Wall Mounting Detail
3/8"
3/8"
5/16"
NUT (4)
5/16"
FRONT VIEW
3/8"
FLATWASHER (4)
PIPE MOUNT
BRACKET
3/8" X 5/8"
3/8"
BOLT
LOCKWASHER (4)
WALL
9