Troubleshooting - Electrolux EWF 1484 EDW Benutzerinformation

13. TROUBLESHOOTING

13.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
13.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
The appliance does not
fill with water and drain
immediately.
Downloaded from www.Manualslib.com
WARNING!
Refer to Safety chapters.
- The appliance does not fill with
water properly.
manuals search engine
•
the water.
•
not closed correctly. Please check the
door!
•
Wait until the mains supply is stable.
•
electronic elements of the appliance.
Switch off and switch on again.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the end
of countdown.
Deactivate the Child Lock function if it is on.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to "Care and cleaning".
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose is cor-
rect.
Make sure that the drain hose is in the correct position. The
hose may be too low.
ENGLISH
- The appliance does not drain
- The appliance door is open or
- The mains supply is unstable.
- No communication between
WARNING!
Deactivate the appliance
before you do the checks.
21