Operations And Controls; Control Panel; Powering On And Off; Basic Controls - Coltene S.P.E.C. 3 LED Benutzerhandbuch

8
• If the light or eye shield obstructs view of the
restoration, UV eye protection may be worn as
an alternate means of protection.
• Do not expose the device or the power supply
to extreme temperatures or open fire. Operate
in ambient temperatures. (recommended
temperature: -5°C ~ +40°C (23°F ~ 104°F).
Malfunction may occur.
• The S.P.E.C. 3
function properly if all of its components are
in good operating condition. Check the device
components thoroughly before use.
- Ensure no components are damaged or
deformed.
- Ensure the main plug and the electrical outlet
socket are compatible.
CAUTION - Check to see if the power cord is damaged.
• When the battery level is critical, the LED display
will turn to ORANGE and start blinking: Please
fully recharge the S.P.E.C. 3
placing the handpiece on the charger base for
2-3 hours. Failure to fully recharge may reduce
battery life.
• Built-in automatic cool-down protection mode:
The S.P.E.C. 3
if its surface temperature is above 45°C (113°F)
for user's safety. The light will flash alternately
between green and orange in the cool-down
protection mode. Place the handpiece into the
charger base and allow the light to cool down
for 5 minutes then try again.
® LED Curing Light will only
® LED handpiece by
LED handpiece will not function
®
EN
V. Operations and Controls

Control Panel

Shot switch

5.1. Powering ON and OFF

• The battery charge level display:
Three green lights indicate a fully charged LED curing light.
One or two green lights indicate the curing light is not
fully charged. The unit beeps one time after displaying the
battery charge level indicating the LED is ready to use.
• Power ON: Press the Shot switch or the Mode switch to
activate the S.P.E.C 3
Power OFF: S.P.E.C. 3
•
automatically after 5 minutes if no operation is detected
(Sleep mode).
• If the curing light is in "Sleep" mode, pressing any
switch will "awaken" the light to the curing mode last
used.

5.2. Basic Controls

• Mode switch:
- Press the Mode switch quickly to select various time
settings.
- Press and hold the Mode Switch for 3 seconds to
switch between curing modes. Two beeps are emitted.
S.P.E.C. 3 LED Curing LIght
®
Mode switch
® Curing Light.
LED Curing Light turns off
®