Introduction; Safety; Explanation Of Symbols; Transport Damage - Coltene S.P.E.C. 3 LED Benutzerhandbuch

4
S.P.E.C. 3 LED Curing Light
®
I.

Introduction

S.P.E.C. 3 LED is a curing light intended for rapid polymeriza-
®
tion of light-cured materials by dental professionals. This product
effectively reduces polymerization time on various light-cured
materials and provides excellent treatment results. S.P.E.C. 3
LED's body is made from industrial-grade aluminum which ensures
its durability and excellent heat dissipation. The S.P.E.C. 3
features multiple curing modes (3K Mode, Standard Mode, Ortho
Mode) for maximum functionality.
Indication For Use: This product can be used for intra- and
extra-oral polymerization of visible light cured dental materials
with Camphorquinone (CQ) photoinitiators. The wavelength
output is 430 nm – 490 nm.
II. Safety
S.P.E.C. 3 LED Curing Light is designed and manufactured in con-
®
formity with applicable safety standards. To prevent damage to
equipment and risks for patients, users, and third parties, please
follow the safety notes and operate with care. Liability can not be
accepted for damage resulting from misuse or failure to operate
in compliance with the safety notes.

2.1. Explanation of symbols

Direct Current
Manufacturer
Manufacturer date
Serial No.
Keep dry
Unstable
Class II Equipment
Double Insulated
Equipment
EN
®
LED
®
CAUTION Consult
accompanying documents
ELECTRIC SHOCK Caution for
electric shock. Risk of fatal injury if
instructions are not followed.
NOTE Consult
Instructions For Use
Type B applied part
Level of protection against electric
shock.
Fragile
Use no hooks /
Do not puncture
Do not look directly into light
emitted from LED
Temperature Limitation
40˚C
104˚F
-5˚C
23˚F
Non-Ionizing Radiation

2.2. Transport damage

Check the device for any damage after receiving it. If damaged,
immediately report to the transportation company within 24
hours from the date of receipt. Under no circumstances, work
with a damaged curing light.
2.3. Operator's obligations
Users must be trained and comply with state or local regulations
in force for this type of device.
2.4. Safety instructions
Before putting the device into operation, read this manual
thoroughly and follow the instructions to avoid any misuse or
damage especially related to user and patient's health. Do not use
this device without proper eye protection for the operator,
assistant and patient.
• Before using the device, check the power
cord and plug for damage. If they are
damaged, do not connect the equipment
to the mains power.
• Do not immerse the product in water.
Moisture should be avoided. Electric
WARNING
shock could occur.
• Keep the product in a dry and clean
place. Exposure to moisture increases
the risk of electric shock.
• Failure to comply may result in injury or
death to personnel.
S.P.E.C. 3 LED Curing LIght
®
Relative Humidity
85%
%
10%
Atmospheric Pressure
106 kPa
80 kPa

Electric Shock Hazard