Gewiss GW 16 972CB Programmierhandbuch Seite 42

USER INSTRUCTIONS
Setting the proportional band
Press the button key
access, the current parameter value is displayed. Adjust using
the circular touch slider or the push-button
the proportional range of the proportional integral control
algorithm for heating
1°C to 10°C), depending on the type of operation selected. To
confirm the set value, press the
seconds; expiry of the time-out (30 seconds) or pressing the
push-button
saving it.
Setting the integration time
Press the button key
access, the current parameter value is displayed. Adjust using
the circular touch slider or the push-button
integration time of the proportional integral control algorithm for
heating or cooling
seconds, "no"), depending on the type of operation selected.
The "no" value excludes the integral component from the
control algorithm, which then becomes a pure proportional
control. To confirm the set value, press the
within thirty seconds; expiry of the time-out (30 seconds) or
pressing the push-button
without saving it.
Setting the cycle time
Press the button key
access, the current parameter value is displayed. Change
through the circular touch slider or the push-button
value of the integral proportional control algorithm cycle time
(possible values are: 5, 10, 15, 20, 30, 40, 50, 60 minutes) fore
heating or cooling
set. To confirm the set value, press the
thirty seconds; expiry of the time-out (30 seconds) or pressing
the push-button
saving it.
42
to access value change; after the
or cooling
button key within thirty
result in exiting the change page without
to access value change; after the
(range can be set from 1 to 250
result in exiting the change page
to access value change; after the
, depending on the type of operation
result in exiting the change page without
the value of
(range can be set from
the value of the
button key
the
button key within