Gewiss GW 16 972CB Programmierhandbuch Seite 38

USER INSTRUCTIONS
"Advanced" parameters
OFF setpoint setting (building protection)
Press the button key to access value change; after the
access, the current parameter value is displayed. Adjust
using the circular touch slider or the push-button the
heating or cooling building protection setpoint
, depending on the type of operation selected. To confirm
the set value, press the button key within thirty
seconds; expiry of the time-out (30 seconds) or pressing
the push-button result in exiting the change page
without saving it.
Setting the temperature measurement unit
Press the button key to access value change; after the
access, the current parameter value is displayed. Select the
temperature measurement unit (°C = Celsius; °F =
Fahrenheit) through the circular touch slider or the push-
button . To confirm the set value, press the button
key within thirty seconds; expiry of the time-out (30
seconds) or pressing the push-button result in exiting
the change page without saving it.
Display back-lighting intensity
Press the button key to access the change to the display light
intensity percentage level; after the access, the current parameter
value is displayed. Adjust the value using the circular touch slider
or the push-button (the range can be set from 30% to 100%).
To confirm the set value, press the button key within thirty
seconds; expiry of the time-out (30 seconds) or pressing the push-
button result in exiting the change page without saving it.
38