––– Procedure 5.7 ––– executable only with a series transmitter Era P and Era W
01
OFF
5.8 - Allocating the shutter/awning's UP and DOWN strokes to the s and t keys on
the control device
This procedure can only be done with a "Mode I" transmitter.
Before starting the procedure, move the shutter/awning to the mid-point of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s and t keys pressed simultaneously and wait for the motor to perform 3 movements. Upon completion, release the keys.
03. Keep the s key pressed and...
• if the shutter (or awning) starts to move in the direction UP keep the s key pressed and wait for the motor to perform 3 movements. Upon completion,
release the key.
• if the shutter (or awning) starts to move in the direction DOWN release the s key and keep the t key pressed, waiting for the motor to perform 3 move-
ments. Upon completion, release the key.
01
5
sec.
03
...
sec.
N.B. – When performing the procedure, you can cancel the programming at any time by keeping the n and t keys pressed simultaneously for 4 seconds Alternatively,
do not press any keys and wait 60 seconds for the motor to complete 6 movements.
––– Procedure 5.8 ––– executable only with a series transmitter Era P and Era W