Operation; System Start-Up - RTW TM3-Primus Bedienungsanleitung

3 | Operation

3.1 | System Start-up

1. At fi rst, place the unit in a way, that there is enough space to connect
the delivered USB connecting cable to a computer or the delivered
USB mains adapter and this to mains supply.
2. Connect the signal source to the unit as described in the 2 | Installati-
on chapter as well as in the 3.2 | Signal Sources section (see below).
3 Connect the delivered USB connecting cable to the unit.
4. Connect the USB connecting cable to the computer or to the USB
mains adapter and this to mains supply. After a short time TM3-Primus
presents the requests for the initial confi guration.
5. After area and domain (analog, digital, USB) have been set, TM3-
Primus will be ready for use.
6. If you want to use a USB audio data stream as signal source, please
defi ne TM3-Primus as a standard audio output device on your compu-
ter system.
Manual | TM3-Primus 3 | Operation | 3.1 | System Start-up
EN
EN-27