Changing The Temperature Scale - Braun 6021 Bedienungsanleitung

Changing the temperature scale

Your Braun ThermoScan is shipped with the Celsius
temperature scale activated. If you whish to switch to
Fahrenheit (°F), proceed as follows:
Make sure the thermometer is turned off.
Press and hold down the «I/O» button. After about 3
seconds the display will show this sequence:
«°C» / «SET» / «°F» / «SET» ...
... ...
Release the «I/O» button when «°F» is shown. There
will be a short beep to confirm the new setting, then
the thermometer is turned off automatically. When
turned on again, temperatures will be shown in
Fahrenheit, until the above procedure is repeated.
Base station for storage, charging,
anti-theft function (optional)
For your Braun ThermoScan PRO 4000, there is a
Base Station available. Contact your distributor for
details (see page 2).
The station automatically recharges the thermometer
(when using the rechargeable batteries supplied with
the base station), and it has an electronic, individually
adjustable anti-theft function. It also serves as a
convenient storage base (can be wall mounted).
It requires returning the thermometer to the station
within an individually pre-selected time. Otherwise
the thermometer will be locked.
When leaving the factory, the anti-theft function of
the PRO 4000 is turned off.
If the anti-theft function is enabled, and when not
in the measuring process (stand-by mode) the
thermometer will show the time remaining before
it is locked.
For turning on the anti-theft function, please refer
to the base station manual.
If the thermometer shows «RET» (without the battery
symbol) on its display, the anti-theft time has elapsed
and the thermometer must be returned to the station
for unlocking.
If the anti-theft function is not enabled, the display
will show «off» when in stand-by mode.
17