Memory Mode - Braun 6021 Bedienungsanleitung

16
5.
For the next measurement, eject the used probe
cover (push ejector (4)) and put on a new, clean
probe cover. The thermometer will turn on auto-
matically.
Wait for the ready signal. Fit the probe snuggly into
the ear canal, then push the Start button.
The Braun ThermoScan ear thermometer turns off
automatically after 60 seconds of inactivity. It can
also be turned off by pressing the «I/O» button for at
least three seconds. The display will shortly flash
«OFF» and after releasing the button it will light-up
permanently.
Temperature taking hints
• The right ear reading may differ from the reading
taken at the left ear. Therefore, always take the
temperature in the same ear.
• The ear must be free from obstructions or excess
earwax build-up to take an accurate reading.
• External factors may influence ear temperatures,
including when an individual has:
– been lying on one ear or the other
– had their ears covered
– been exposed to very hot or very cold temper-
atures, or
– been recently swimming or bathing.
In these cases, remove the individual from the
situation and wait 20 minutes prior to taking a
temperature.
• For persons wearing hearing aids or ear plugs,
remove the device and wait 20 minutes prior to
taking a temperature.
• Use the untreated ear if prescription ear drops or
other ear medications have been placed in the ear
canal.

Memory mode

The last temperature taken before the Braun
ThermoScan is turned off is stored in its memory
and will be automatically displayed when it is turned
on again. The display will show «MEM».
For longer display of the stored reading, the thermo-
meter must be turned on and the «I/O» button must
be pressed for at least 1 second.
The memory mode is left automatically after pressing
the «I/O» button for at least 1 second.