Attaching The 7-Inch Viewfinder - Sony BVP-900 series Bedienungsanleitung

Setting Up the Camera

Attaching the 7-inch Viewfinder

For details on attaching a viewfinder, refer to the
instruction manual furnished with the viewfinder.
Proceed as follows.
Bottom of the viewfinder
1
VF connector
1
Place the viewfinder on the viewfinder mount of
the camera so that the mounting wedge on the
bottom of the viewfinder enters the V-shaped
recess on the viewfinder mount and that the
projections on the bottom of the viewfinder are
placed at the position shown in the figure above.
2
Push the viewfinder by the handle so that the
panning base is securely held by the viewfinder
mount.
Pull the handle to check that the viewfinder is
fixed to the camera.
3
Turn the viewfinder counterclockwise.
18 (E)
Projections
Panning base
Mounting wedge
Viewfinder mount
V-shaped recess
Pan-friction screw
Attaching a 7-inch viewfinder to the BVP-900/900P
Note
Be sure that the VF connector on the viewfinder mount
is positioned at a right angle to the control panel of the
camera.
2
3
Adjusting the pan-friction of the viewfinder
You can adjust the friction for panning the viewfinder
with the pan-friction screw. The friction increases as
the screw is turned clockwise, while the friction
decreases as the screw is turned counterclockwise.
Caution
Attach the viewfinder to the camera securely, or the
viewfinder may fall down.