Sony BVP-900 series Bedienungsanleitung Seite 15

Rear panel of the BVP-900P
The functions of the switches and control numbered 1
through #º, see "Rear panel of the BVP-900".
#¶ INTERCOM connector (XLR 5-pin)
• Connect an XLR 5-pin-type headset. The left
INTERCOM connector can be used for
communication even if the power to the camera is
turned OFF on the CCU-700AP. You can use the
right INTERCOM connector for an RTS intercom
system by installing an optional BKP-7913 RTS
Intercom System Kit, and two RTS Belt-pack can be
connected.
• You can monitor playback audio from the VTRs
when using the BVP-900P as a stand-alone unit.
#• TRACKER control
Adjusts the intercom level with the tracker.
#ª ENG (engineer line) control
Adjusts the intercom level of the engineer line.
TRACKER ENG
INTERCOM
#¶
INTERCOM connector
#•
TRACKER control
#ª
ENG control
1
MIC
ENG PROD
OFF
PROD PGM
INTERCOM
#¶
INTERCOM connector
$™
PGM control
$¡
PROD control
$º
MIC switch
$º MIC (microphone line select) switch
Selects the line to which the microphone of the headset
is to be connected.
ENG: For connecting to the engineer line.
OFF: For turning off the microphone.
PROD: For connecting to the producer line.
$¡ PROD (producer) control
Adjusts the intercom level of the producer line.
$™ PGM (program audio level) control
• Adjusts the output level of the program audio.
• This control adjusts the level of the playback audio
signals of the VTR when the BVP-900P is used as a
stand-alone camera.
13 (E)