Sony BVP-900 series Bedienungsanleitung Seite 17

Caution
Before mounting a CCD unit to the camera, be sure to
turn the power of the camera off, and disconnect a
triax cable or a cable connected to the DC IN
connector on the camera. If the CCD unit is mounted
to the camera to which the power is supplied, fire or
trouble may occur.
Proceed as follows.
1
Remove the red connector cover from the rear of
the CCD unit.
2
Loosen the lens-lock knob, turn the lens lock
counterclockwise, and remove the front cover.
3
Loosen screw A on the front, and open the
insertion-prevention plate.
4
Insert the CCD unit, and secure it with the four
mounting screws B.
Fasten the screws securely with a coin or similar
tool.
5
Turn the mounting lever on the CCD unit fully
counterclockwise, and remove the mounting cap.
6
Turn the mounting lever clockwise to its lowest
position.
7
Close the insertion-prevention plate, and secure it
with the screw A.
Notes
• Be sure to mount the CCD unit to the camera
securely and correctly. Otherwise it may be
damaged.
• Be sure to fully turn the mounting lever to its lowest
position. Otherwise the lens may be damaged.
• Be sure to close the insertion-prevention plate and fix
it securely. Otherwise the lens cannot be mounted.
15 (E)