Sony BVP-900 series Bedienungsanleitung Seite 9

!∞ REMOTE connector (8-pin)
Connect an optional master setup unit or remote
control unit/panel using a CCA cable. Then you can
control the camera with these units.
!§ Accessory bracket
Attach an optional accessory, such as a BKP-7911/
7912 Script Holder or focus/zoom demand.
For attaching the accessory, refer to the instruction manual
supplied with the accessory.
!¶ AC OUT (AC power output) connector
Supplies AC power (200 VA maximum).
!• CCU (camera control unit) connector
(triax connector)
Connect to the CAMERA connector on a CCU-700A/
700AP using a triax cable. All of the signals in a
BVP-900-series camera system such as the power,
control, video, and audio signals can be transmitted
between this unit and a CCU-700A/700AP using a
single triax cable.
!ª REF IN (reference signal input) connector
(BNC type)
Accepts a VBS or black burst signal for gen-lock when
using the BVP-900/900P as a stand-alone camera.
@º VBS (video signal output) connector
(BNC type)
Supplies composite video signals when using the BVP-
900/900P as a stand-alone camera.
@¡ VTR connector
Connect a VTR using a CCZ or CCZQ cable when
using the BVP-900/900P as a stand-alone camera.
@™ DC IN (DC power input) connector
Connect a DC power source (11.5 V to 18 V) when
using the BVP-900/900P as a stand-alone camera.
....................................................................................................................................................................................................................................................
1) These connectors are equipped with the BKP-7910/7910P
Stand-Alone Kit.
1)
1) (26-pin)
1)
(4-pin)
1)
7 (E)